On many lakes throughout the U.S. and Canada you will find docks which are installed in the Spring and removed in the Fall. Stationary docks which are supported on the bottom of the lake on poles generally come apart in sections that are fairly light and can be done by hand. Sometimes large plastic wheels are permanently attached to the bottom of the dock poles. Often the fixed dock is light enough and rigid enough that a 30′ long section can be rolled right out of the lake and stored on the beach for the winter.
Floating docks typically use Inflatable Floating Platform and they are either made entirely of polyethylene, or have a wood, aluminum, or composite deck that sits on the top of the plastic floats. Floating docks weigh considerably more per foot than fixed docks. This additional weight causes it to be harder to make a long rigid structure that is certainly light enough to get completed by hand. Usually the longest floating dock sections are restricted to about 10 feet. For too long docks, the ten foot sections are connected with flexible connectors. These docks are generally removed through taking the sections apart and hand carrying them out of the water, one 10 foot section at any given time. In case you have an even beach, you could possibly drag the fully assembled dock the beach having an ATV or SUV. Sometimes individuals will use PVC pipe as rollers beneath the dock and so the dock lacks to drag on the sand.
You will find manufactures now making floating docks that could have a single rigid section that is up to 32 feet long. These docks are made from structural aluminum bolted together to form a 24″ tall truss running the length and width in the dock. Polyethylene floats are caged inside the truss system and a lot common dock materials can be used the deck. These truss type structures are light enough and robust enough to allow wheels to be mounted beneath the dock. When the dock is designed to be rolled the beach, polyethylene wheels could be mounted similarly to the people applied to stationary docks. In the event the shoreline is too steep or it is really not convenient to keep the dock along the shore, a highway rated axle, wheels, and tires could be installed. The axle is galvanized as well as the bearings are usually protected having a military technology that is designed to maintain positive air pressure inside the bearing cavity for one year of Drop Stitch Fabric. A square or rectangular aluminum tube can be mounted under one end of the dock. This tube works as a receiver for a 6′ long trailer tongue that can insert about 2′ and after that pin in place. There exists a trailer coupler on the extended end from the tongue that is designed to connect with a trailer hitch having a standard 2″ ball.
The dock could be towed across the water to some standard boat launch ramp where tongue is inserted into the receiver turning the dock into a floating trailer. An easy duty truck or SUV backs down the launch ramp up until the coupler may be floated over the trailer ball. The coupler is locked on and also the truck pulls the dock from the launch ramp much like it was a boat over a trailer. The dock may be towed on the highway two miles or 200 miles. Temporary trailer lights may need to be installed depending on the distance and terrain traveled.
This new “Rolling Floating Dock” technology has dramatically reduced the irritation of installing and removing floating docks. Especially benefited are the types waterfront sites that are very steep and also have little if any beach. Floating Docks can be purchased that are approximately 17′ wide but may be folded up within the launch ramp parking area to simply 8.5′ wide so no special highway permits gbpman needed. Some docks could also include a large second deck. Big docks that are simple to install and take off can make up for the beach that many lake front owners wish they had.
Some manufacturers can also license the dock as being a boat allowing it to be motored across the lake with an outboard and tiller handle. These docks be a safe, fun, and mobile platform for swimming and fishing. While technology is racing around us, it is actually nice to see that a number of that technology is giving us safe places to unwind on Inflatable Drop Stitch with our minds comfortable realizing that the work of closing up for the winter will be quick and simple.